Step 1: a DVA body to have a base to start with.

 

Roof removed, wheelbase adjusted to correct measure, styrene sheet placed where 917 dash was.

 

Tail is shortened to appropriate measure.

 

Use of plenty of plaster....

 

...and beginning to shape the sides.

 

Nose is cut to the appropriate lenght, styrene added underneath rear panel, more plaster on tail too.

 

Styrene glued on tail, and more shaping. Use of a soft pencil to accent the body line on the sides.

 

Wheelbase measure is... just right!

 

 

 

 

 

 

 

 

 

 

 

Continue to Page 2----->

 

 
DVA Dolermo Models, Inc.   -   Po Box 2  -   Jarrettsville, MD-21084  (USA)
(410) 692-7942  -  dvamodels@yahoo.com